Small 3D printed airplane

In this project, I design an aircraft for pleasure and flight training now, when only airplanes with mass less than 150 g are allowed to fly.


This airplane is going to be wing-tail, with ailerons and elevator only, without flight controller. Very basic, very simple, light, and cute.
August 17, 2026


The wing and aileron design has been completed and printed:)
September 13, 2026


The model is ready for printing!
September 13, 2026


I start with Creality Hyper PLA, with standard slicer
settings, and:
layer height 0.08 mm
infill 2%
2 wall loops
Made on
Tilda